Well... Yes. As a matter of fact, the same website that displays the sprinkler control template also shows the cameras connected to Blue Iris. And each camera view that includes a view of a specific set of landscape lights (front, side, rear, etc.) also allows control of those lights on that specifi...

I appreciate your interest! I wish it was a greater thing that it actually is. What the graphic is ... is a diagram of my lot surrounding my home. The lot is divided into 7 zones. Each zone is actually a sprinkler zone. So you can click on an area and that sprinkler zone turns on. Click on another z...

Actually... the graphic is used as a geographic template. Whereby you can click with a mouse or touch with your finger in various areas on the graphic to perform various functions in various locations.

No. Really no need until you realize you should have done that yesterday.
I like to wait until the day after I should have done it.

Thank you for your interest! I figured out how to display the single graphic. I ended up doing it two different ways. One: using a GIF and one using a JPG. Each of which makes more sense than using an AVI video which I had been doing. The "yard.jpg" graphic is in the "www" folder...

I'd like to display a stationary graphic in place of camera video. I have a short .avi if 'video' is needed and I have a single graphic jpg and gif if those would work better. All are in the Blue Iris www folder. They are 352 x 240 and rotated 270 degrees. Prior to a hard drive failure, it worked fo...

When a loss of signal is detected, I would like to have an email sent immediately and then every 30 minutes until the signal is restored. Instead, an email is sent every 60 seconds or just one time depending upon whether "Continue alerting until signal is restored" is checked. Is there a w...

So does anyone use the Watchdog utility to send an email upon camera failure?

Blue Iris 4 When a loss of signal is detected, I would like to have an email sent every 30 minutes. In the "Configure Email alert" window, "Timer" is set to "Wait at least 30.0 min. between alerts". However, an email is being sent every minute during a failure. "Li...

@BlueRIdge Did you ever hear from BI about viewing of a camera on Echo? I have not been successful in having Echo even discover the BI connected cameras. When I click on "Connect to Amazon Echo", Echo does not find new devices after a search. And that is after setting each camera's "A...