It is running under Windows 11 on my server direct. Used to have it virtualized but had the server spare so went for the un-virtualized way. The drives are controlled by the RAID controller and are passed through to the OS depending on how they are set up. I just have them set up as RAID0 and pass e...

Oh the camera is working just fine. I hooked it to my Synology and it displayed a picture fine. Half way through today my Lenovo X3650M5 once again failed through the IMM and same warning message of "The following VDs are missing: 000" Was able to once again clear it and rebooted the serve...

Power was shut off to my house for 2 hours. The PC shut down once the UPS power ran out. Once the power came back up there appeared to be issues with my Lenovo X3650M5 saying there was drive issues. Finally cleared this and got it to boot up. The software went through and rescaned all the alerts whi...

I am running 5.9.2.2 and see the memory usage creep most times i edit something. Something simple as changing the short name for the camera caused the memory to go from 300 - 500MB to 5.5GB in about 2 hours. I restarted the service and it reverted back to the 300-500MB and has been steady the last 2...

Okay I just made changes to the cameras short names which stopped and restarted 3 of the 5 cameras. After an hour the memory usage has climbed from a steady 300 - 500MB for the last 24 hours to 5.5GB of usage. Definitely a big memory hole there somewhere so yes I have the same issue as you. Good aft...

I had a similar issue. Two cameras would not connect after a restart. Turned out I turned on the speaker icon on the main overview. The two cameras in question could not handle the audio request. As soon as I turned it off they both came back without a restart.

Not sure. I was changing stuff on a new camera. I watched mine for quite a while and it peaked at 96% of the memory used and actually dropped back to 62% for a short time before climbing up again to around 96% and then the system became unstable and I had to shut the Lenovo x3650M5 server down. I ha...

I have Blue Iris set up with 5 cameras and AI to detect people. Up until this morning the system was running fine. I have 32GB of memory and the specs say BI will run with 4GB. This morning the App showed my memory usage at 96% and I remoted in and sure enough BI was using nearly all of the 32GB. It...

Gotta hate it when you post and then find the answer yourself just after.

Turns out ONIF and other stuff was turned off in the camera by default and had to be turned on. Found it deep in the settings menu of the camera.

I have just got the camera and i see it fine in a web browser. All working as it should. I went to add it to Blue Iris but it can't seem to find anything. I input the IP address and set it as Generic and click the inspect button but only get the following. I tried the Reolink type as well with same ...